Free Instructions: Trio Pendant

A super simple, but super stylish pendant, follow our instructions to make exactly the same pendant as we have, or us our design as a starting point to develop further! Use silver plate with gold plate, add a crystal dangle onto the bottom circle, repeat all the steps again, and make a pair of earrings, there are so many options!

Material needed

3 x 7mm jump rings ( JR7 )

12 x 5mm jump rings ( JR5GP )

1 x 12mm circle link ( MT1ELGP )

1 x 18" assembled curb chain ( CHE18GP )

Tools Required

Two pairs of chain nosed pliers ( BEECN )

Instructions:

TIP: When you are closing your jump rings, be as careful as you can and close them as neatly as possible, as to not draw any attention to the jump ring join

1. Using chain nosed pliers, open up one 7mm jump ring, and loop two 5mm jump rings onto it. These two jump rings will be the top of your pendant, the chain will pass through these at a later step, so keep these at the top ( photo 1 )

2. Open one 5mm jump ring, loop it onto the 7mm jump ring from the previous step, and a new 7mm jump ring. Repeat this with two more jump rings ( photo 2 )

3. Open one 5mm jump ring, loop it onto the 7mm jump ring from the previous step, and the 12mm open circle link. Repeat this with three more jump rings ( photo 3 )

4. Open the top two 5mm jump rings from step 1, loop onto your assembled curb chain, and loop a new 5mm jump ring across both the jump rings. Close the two open jump rings ( photo 4 )

5. The next row of three jump rings below; open them up and loop a new 5mm jump ring across them. Close the open jump rings ( photo 5 )

6. The next row of four jump rings below; open them up and loop a new 7mm jump ring across them. Close the open jump rings ( photo 6 )

You're finished!

You can change up our design how you like! .....follow our instructions again, and make a pair of earrings.....use silver plated as well as gold plate, or add a little sparkly dangle! What will you make? We would love to see!